Information Specific to Hammond Enclosures

Type 12 and Type 4 Enclosures

INSTRUCTIONS FOR REPAINTING HAMMOND POWDER COATED PRODUCTS

Note: Always test the repainting process in an inconspicuous area prior to use.

• ■All Hammond standard powder coated products can be repainted.
• ■Check with your paint manufacturer to insure that the paint you are applying is compatible with the paint on the Hammond product.
• ■(Hammond uses Polyester and Hybrid powder coatings on standard catalogue products) - Always test the repainting process in an inconspicuous area prior to use.
• ■This painting instruction applies to ANSI 61 (Gray) and RAL7035 (Light Gray).
• ■All other Hammond powder paints can be repainted by following step 5.
• ■IMPORTANT - This step is mandatory and must be done carefully.
• ■Wipe down the entire area to be repainted with lacquer thinner or acetone. Use a clean cloth and change cloth frequently.
• ■Apply finish coats as per your paint manufacturers instructions.
• ■Allow paint to cure properly for best adhesion and hardness. Consult your paint manufacturer for proper cure time and temperature.
• ■The above procedure promotes good inter-coat adhesion. To enhance this process sanding with a 220 grit sandpaper is recommended. Remove all sanding dust using clean rags and a tack cloth.
• ■All Hammond standard powders can be repainted after a light sanding with a 240 grit sandpaper and cleaning.