Hammond FLHTF800A230 800W 220/240V Enclosure Fan Heater with Thermostat

The FLHTF800A230 is a fan-forced enclosure heater with a built-in thermostat, rated 670/800 W (at 220/240 V) on 220/240 V, 50/60 Hz and moving 20 CFM. It is designed to prevent condensation or maintain a minimum temperature inside a control panel or metal enclosure, protecting critical components from freezing and condensation. It is not intended as a comfort or space heater.

The housing measures 7.5" x 4.0" x 5.3" (H x W x D) in the ordering table, with 189.87 mm [7.475 in] x 101.60 mm [4.000 in] x 133.86 mm [5.270 in] shown on the part drawing. The drawing lists UL Recognized to UL 508A and CSA Standard C22.2 No. 88 approvals, under UL File E331157. The drawing lists the rating as 220/240 VAC, 50/60 Hz, 670/785 W, while the ordering table shows 670/800 W.

The outer casing is aluminum alloy. The adjustable thermostat covers -18 C to +38 C (0 F to +100 F), and a Fan Auto/On switch with pilot light shows when heat is on. In FAN mode the fan runs continuously for more uniform temperature distribution and heat is still provided below the set point; in AUTO mode the fan cycles on only when the heating element is energized. An automatic reset temperature limit switch breaks power to the element on fan failure or overheat.

Mount the FLHTF800A230 vertically inside a metal enclosure on a metal surface, terminal block at the bottom and discharge vents at the top, using four #10 metal screws, as low and central as possible. Keep heat-sensitive components clear of the vents by the FLHTF800 clearances (8in / 200mm X, 2in / 50mm Y). Wiring is by qualified personnel with wire rated at least 90°C; there is no OFF position, so disconnect supply power to shut it down.